How to change the combination on a cannon gun safe

How to change the combination on a cannon gun safe how to#
How to change the combination on a cannon gun safe code#

Step #1: Turn the dial of the safe the wrong way. Rubber Mallet: This will be used to hit the safe.If your digital safe has a dial, this is the best technique that you can use. 5 Best cordless hammer drills Technique #2: The Dial Technique.You need to repeat the steps and this time, make sure that you will be entering the correct code. If the safe still fails to open, you may have entered the wrong combination on the inner keypad of the safe. It should easily pop open after entering the code.

How to change the combination on a cannon gun safe code#

Now, you should enter the new code in the keypad located outside the door of your safe. Step 4: Enter the new code at the safeвЂ™s exterior keypad. You will hear a beep that will signal that you are successful in replacing the safe combination. After resetting the code, enter in your new password combination in the inner keypad.ДЄfterward, use the wire to press the set button which you would usually find just beside the reset button. Slide the wire through the hole and use it to press the red button in the keypad of your safe. But if the hokes are a bit smaller than a coat hanger, you can buy any stiff roll of wire in a nearby hardware store. You can use a straightened coat hanger for this purpose. It is easy to spot as it contains keypad and a few other control buttons. Inside the safe, look for the back panel where the electronic part of the safe is placed. If your safe has a two-hole style, you can peek through the opposite hole. Hold your flashlight to the hole then peek through it. Using your flashlight, look for these bolt openings or holes. You can use these to rest the code of the safe. These holes are where bolts are fed through. Most electronic safes, most especially the smaller safes, have a small hole either at their back or bottom portion. Step 1: Look for the bolt openings at the back of your safe. Just make sure that this new code is easy to remember but hard to crack. You will use this to replace your old safe code. This is needed for pressing the reset button of the safe. You will use this to locate the bolt openings at the back of the safe. This technique takes advantage of the weak spot that digital safes have and will allow you to crack the safe without having to tear apart the safe manually.

How to change the combination on a cannon gun safe how to#

How to Open a Digital Safe Without a Combination 2 Way on how to open a digital safe without a combination Technique #1: The Reset Technique